A Ironworks company - serving Anaheim, CA

Ghost Controls Keypad & Intercom Repair Nationwide

Every visit starts with

Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted

The assessment is free and the quote is the invoice.

Styles & brands we work with

Wrought iron
Wrought iron
Wood & steel frame
Wood & steel frame
Farm & ranch
Farm & ranch
Sliding driveway gates
Sliding driveway gates
LiftMaster operators
LiftMaster operators
Before & after – our own jobs

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Ghost Controls Keypad & Intercom Repair: The Anaheim Owner’s Guide

Ghost Controls keypad and intercom repair in Anaheim typically runs $190 to $430 installed, and most jobs are completed the same day we arrive at your driveway. We stock Ghost Controls-compatible keypads, intercom boards, and wiring kits on our trucks, which means we’re not waiting on a parts shipment while your gate sits open overnight. The usual story we hear goes like this: the keypad beeped a little softer for a few weeks, then the buttons stopped lighting up, and now the gate only opens from the clicker in the car. Nobody notices a keypad fading until it’s fully gone.

Call (424) 395-3381

Key takeaways:

  • Most Ghost Controls keypad and intercom failures are repairable in one visit without replacing the entire opener.
  • Parts are priced and agreed upon before any work starts. No surprises on the bill.
  • We’re an independent gate company. We’re not affiliated with Ghost Controls, but we service their equipment daily and stock compatible parts for it.
  • Every repair carries our written 90-Day Done Right Promise.

Which Ghost Controls Models This Applies To

Ghost Controls makes three main lines that show up on Anaheim driveways: the original AX series, the current R series, and the newer adjustable-speed models. The keypad and intercom components on all three share the same core design, so a failure on an AX12 from 2018 looks nearly identical to a failure on an R-series unit installed last year. The main compatibility gotcha is the wire gauge. Ghost Controls keypads and intercoms run on a two-wire, low-voltage connection back to the control board, and older Anaheim installations often used whatever wire the original installer had in the truck. If that wire is 20-gauge or thinner and run more than 25 feet, it degrades the signal and makes a healthy keypad act like a failing one. We check the wire before we condemn the part, because the part is rarely the whole story.

We carry OEM-quality replacements and, where the factory part has been discontinued or backordered for months, proven aftermarket equivalents that match the voltage draw and connector layout. Victor Salinas tests every substitute on our bench before it goes in your gate. If your Ghost Controls unit still has its original metal keypad face, that’s the tell that it’s a first-generation AX model, and the replacement keypad housing is slightly different in size. We account for that on site.

Signs Your Ghost Controls Keypad & Intercom Is Failing

  • Fading backlight. Ghost Controls keypads use a small LED backlight that dims as the internal circuit board wears. If you’re holding a phone flashlight to read the buttons at night, the keypad is on borrowed time. The cause is almost always a failing voltage regulator on the keypad board, not dead batteries.
  • Intermittent response. You type the code, nothing happens, you type it again and the gate opens. This is commonly a corroded wire terminal at the keypad connection point, a problem Anaheim’s damp spring mornings and inland heat cycles make worse. The steady expansion and contraction loosens terminals over time.
  • Buttons that need extra pressure. The rubber dome switches under the buttons on Ghost Controls keypads compress with years of use and stop rebounding cleanly. If you press “4” and the keypad registers it on the third try, that’s not a low-battery problem. It’s the switch layer degrading, and it’s a normal wear item on keypads older than about five years.
  • Ghost activations. The gate opens on its own without anyone keying in. On keypad systems this is usually a failed capacitor leaking current to the trigger circuit. It is not a ghost, it’s a tiny component that costs a few dollars, but it must be diagnosed before it drains your system or burns the control board.
  • Dead intercom with static or no audio. If the call button lights up but you can’t hear the visitor, the issue is usually in the intercom’s small audio amplifier or a corroded speaker terminal. Salt air from the coast works its way inland to Anaheim and accelerates corrosion on exposed wiring nodes. We see more of this in west Anaheim than in the hills.

Replacement Cost & What’s Included

In Anaheim, expect $190 to $430 for a Ghost Controls keypad or intercom replacement, depending on the model line and whether it’s a keypad only, an intercom only, or a combined unit. A straightforward keypad swap on a recent R-series opener lands around $190 to $260, labor included. A full keypad-and-intercom unit, particularly on an older AX-series gate, runs higher because the housing, wiring harness, and sometimes a rusted mounting plate need attention too. If we find a deeper problem with the wire run or the control board, that gets priced separately and shown to you in writing before we do it.

Every quote we give in Anaheim is a fixed price, parts and labor together, and you approve it before a single bolt comes off. The repair is covered by our 90-Day Done Right Promise in writing. If the new keypad misbehaves in the next three months, we’re back to fix it at no charge. That’s the deal we’ve stood behind for over 42 years.

DIY or Call Us?

Because Ghost Controls keypads and intercoms carry only low-voltage current, this is one of the safer gate components to inspect. You can safely check the keypad mounting screws, clean the button face with a damp cloth, and verify that the wire terminals are not visibly pulled loose. What you should not do is open the keypad housing and start poking at the circuit board with a multimeter unless you work with electronics regularly. A short from a slipped probe can take out the opener’s control board, turning a $200 keypad replacement into a $500 control board job before lunch. If the intercom has been exposed to rain or sprinkler spray, leave the diagnostics to someone who’s seen the failure before.

If the keypad is flaking out or the intercom has gone quiet, call us at (424) 395-3381. We’ll tell you what we think over the phone, and if a visit makes sense, we’ll give you a straight price when we see the gate. No dispatch fee, no obligation.

FAQs

Need Gate Repair help in Anaheim? Licensed & insured · within the hour response · free estimates
Call (424) 395-3381
Local Service Coverage

Request a Free Estimate in Anaheim

Tell us what you need - Ironworks Gate Co. responds fast. No obligation.

By sending this request, you agree to the terms of our Privacy Policy and consent to being contacted by telephone, text message, or email about your request, including by the independent professionals who may fulfill it.

Prefer to text? Send a Text
Call Now - 24/7 Dispatch